CertsTopics Logo

Weekend Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

Fortinet Certified Solution Specialist FCSS_NST_SE-7.4 Release Date

Page: 3 / 5
Total 66 questions
Get FCSS_NST_SE-7.4 Full Access Download FCSS_NST_SE-7.4 PDF

FCSS - Network Security 7.4 Support Engineer Questions and Answers

Question 9

Refer to the exhibit, which a network topology and a partial routing table.

FortiGate has already been configured with a firewall policy that allows all ICMP traffic to flow from port1 to port3.

Which changes must the administrator perform to ensure the server at 10.4.0.1/24 receives the echo reply from the laptop at 10.1.0.1/24?

Options:

A.

Enable asymmetric routing under config system settings.

B.

Change the configuration from strict RPF check mode to feasible RPF check mode.

C.

A firewall policy that allows all ICMP traffic from port3 to port1.

D.

Modify the default gateway on the laptop from 10.1.0.2 to 10.2.0.2.

Question 10

Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

Options:

A.

The administrator must also run the command diagnose debug enable.

B.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

C.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

D.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

Question 11

Exhibit.

Refer to the exhibit, which shows the output of a diagnose command.

What can you conclude about the debug output in this scenario?

Options:

A.

The first server provided to FortiGate when it performed a DNS query looking for a list of rating servers, was 121.111.236.179.

B.

There is a natural correlation between the value in the FortiGuard-requests field and the value in the Weight field.

C.

FortiGate used 64.26.151.37 as the initial server to validate its contract.

D.

Servers with a negative TZ value are less preferred for rating requests.

Question 12

Refer to the exhibit, which shows the port1 interface configuration on FortiGate and partial session information for ICMP traffic.

What happens to the session information if a routing change occurs that affects this session?

Options:

A.

Only the interface and gateway information for dev=7 will be removed.

B.

The session information will not change unless the current route has been removed from the routing table.

C.

The session will be flagged as dirty but no route lookups will be performed.

D.

Sessions involving port7 or port19 will not have their routing information flushed.

Page: 3 / 5
Total 66 questions
Get FCSS_NST_SE-7.4 Full Access Download FCSS_NST_SE-7.4 PDF