All PCNSE Test Inside Paloalto Networks Questions

When using the log forwarding built-in action with tagging in Palo Alto Networks firewalls, the primary purpose is to dynamically respond to threats or unwanted traffic identified by the firewall's threat detection mechanisms. The action involves tagging the IP address associated with the unwanted traffic and then using that tag in dynamic security policies to block or manage the traffic.

A. Destination IP addresses of selected unwanted traffic are blocked:

When the tagging action is used, the firewall tags the IP addresses involved in the unwanted traffic (which could be the source or destination IP addresses, but in many configurations, the focus is on the source of the attack). These tags can then be referenced in Dynamic Address Groups (DAGs) within security policies. Consequently, any traffic coming from or going to these tagged IP addresses can be blocked or subjected to specific security rules, effectively mitigating the threat or unwanted behavior.

This approach allows for automated, real-time responses to identified threats, enhancing the security posture by quickly adapting to emerging threats without manual intervention.

The firewalls exchange hello messages and heartbeats at configurable intervals to verify that the peer firewall is responsive and operational. Hello messages are sent from one peer to the other to verify the state of the firewall. The heartbeat is an ICMP ping to the HA peer. A response from the peer indicates that the firewalls are connected and responsive.

"A "heartbeat-interval" CLI command was added to the election settings for HA, this interval has a 1000ms minimum for all Palo Alto Networks platforms and is an ICMP ping to the other device through the HA control link."

"- Force Template Value will as the name suggest remove any local configuratio and apply the value define the panorama template. But this is valid only for overlapping configuration" "You need to be careful, what is actually defined in the template. For example - if you decide to enable HA in the template, but after that you decide to not push it with template and just disable it again (remove the check from the "Enable HA" checkbox). This still will be part of the template, because now your template is explicitely defining HA disabled. If you made a change in the template, and later decide that you don't want to control this setting with template, you need to revert the config by clicking the green bar next to the changed value"

When implementing an application override in a Palo Alto Networks firewall, the primary goal is to explicitly define how specific traffic is identified and processed by the firewall, bypassing the regular App-ID process. This is particularly useful for traffic that might be misidentified by App-ID or for applications that require special handling for performance reasons.

To successfully implement application override, the following items must be configured:

B. Application override policy rule:

This is a specialized policy rule that you create to specify the criteria for the traffic you want to override. In this rule, you define the source and destination zones, addresses, and ports. Instead of relying on the App-ID engine to identify the application, the firewall uses the criteria defined in the application override policy to classify the traffic.

C. Security policy rule:

After defining an application override policy, you must also configure a security policy rule to allow the overridden traffic through the firewall. This rule specifies the action (allow, deny, drop, etc.) for the traffic that matches the application override policy. It's essential to ensure that the security policy rule matches the traffic defined in the application override policy to ensure that the intended traffic is allowed through the firewall.

For detailed guidance on configuring application override and the necessary security policies, refer to the official Palo Alto Networks documentation. This resource provides step-by-step instructions and best practices for effectively managing traffic using application overrides.