DELL EMC DES-3128 Exam With Confidence Using Practice Dumps

This behavior can occur when persistent naming is enabled on the storage node. When persistent naming is enabled and the storage node is rebooted, the library and tape drives may no longer be accessible because the persistent naming is lost.

References: [1]   [2] 

To create the desired configuration, you will need to use the Data Domain CLI (Command Line Interface) to access the DD Boost device and create the new appliance. Here are the steps:

• Log in to the Data Domain CLI by entering the following command:

ssh ddboost@DD0

• Enter the password "abc123" when prompted.
• Once logged in, create a new DD Boost device named DD01.SU01 by entering the following command:

ddboost device create --name DD01.SU01 --type vmware --pool DO.VMware_Pool

• Verify that the new device has been created by running the following command:

ddboost device show --name DD01.SU01

• Configure the DD Boost device to connect to the PowerProcted DO series appliance by running the following command:

ddboost device set --name DD01.SU01 --dd-host DD0

• Verify the configuration by running the following command:

ddboost device show --name DD01.SU01

To create a new NSR Client "ABC 123" and PSS file system backup save sets /data01 and /data02, and a skip files directive named "Skip GO" for * .go extensions anywhere under /data02, the administrator can use the Networker CLI (Command Line Interface) to access the Networker server and create the NSR Client, PSS file system backup save sets, and skip files directive. Here are the steps:

• Log in to the Networker CLI by entering the following command:

nsr_client -C ABC 123

• Once logged in, create a new PSS file system backup save set for /data01 by running the following command:

savefs -p -s /data01

• Create a new PSS file system backup save set for /data02 by running the following command:

savefs -p -s /data02

• Create a skip files directive named "Skip GO" for * .go extensions anywhere under /data02 by running the following command:

savefs -p -s /data02 -k "* .go"

• Verify that the new NSR client, PSS file system backup save sets and skip files directive have been created by running the following command:

nsr_client -l

• Verify that the new PSS file system backup save sets are correctly associated with the new NSR client by running the following command:

nsr_client -G ABC 123