VMware 5V0-22.21 Exam With Confidence Using Practice Dumps

The correct answers are D. Login on MyVMware, and download the vSphere and vSAN software bundles and E. Verify the supportability of the software, hardware, drivers, firmware, and storage I/O controllers on the VMware Compatibility Guide. Before upgrading the vSAN cluster, the administrator should first login to MyVMware and download the vSphere and vSAN software bundles, and then verify the supportability of the software, hardware, drivers, firmware, and storage I/O controllers on the VMware Compatibility Guide. Once the compatibility has been verified, the administrator can proceed with disabling vSphere DRS and vSphere HA in order to avoid VMs and data from moving among the nodes during the vSAN upgrade process, and then put the host in maintenance mode with "Ensure Accessibility".

VMware vCenter Server 7.0 Update 1 Release Notes

VMWARE TRADEMARK GUIDE

vSAN Monitoring and Troubleshooting - VMware vSphere 7.0

C. Enter Maintenance Mode, confirm that pre check is fine, select "Full data migration", "Shutdown ESXi host", replace all capacity devices, "Restart ESXi host", replace capacity devices in disk groups, exit Maintenance Mode, confirm that raw capacity has been increased, and then repeat on ESXi host one-by-one. D. "Shutdown ESXi host", and replace all capacity devices. Repeat this sequence one-by-one.

Option C would allow you to perform a full data migration, which will move all data from the old capacity device to other devices. This option allows for the vSAN cluster to remain offline during the replacement process, and it allows the vSAN administrator to replace all the capacity devices at once.

Option D would also allow you to replace all capacity devices at once, however, the data is not moved from the old capacity device to other devices, this option also allows for the vSAN cluster to remain offline during the replacement process and it allows the vSAN administrator to replace all the capacity devices at once.

You can find more information on adding capacity to a vSAN cluster in the vSphere 7.0 documentation: and also in VMware blog like:

The two approaches the vSAN administrator can use to complete this task are C. Enter Maintenance Mode, confirm that pre check is fine, select "Full data migration", "Shutdown ESXi host", replace all capacity devices, "Restart ESXi host", replace capacity devices in disk groups, exit Maintenance Mode, confirm that raw capacity has been increased, and then repeat on ESXi host one-by-one and D. "Shutdown ESXi host", and replace all capacity devices. Repeat this sequence one-by-one. Reference: